Ampire 3606V Manual de Instalação descarregar pdf (Página 11)

20 21

Sensor Warn-away output

When the system sensors detect a Warn-away trigger the siren chirps

and parking lights ﬂash for 3 seconds.

Full Trigger output

An alarm Full Trigger will sound the siren and ﬂash the parking lights

for 30 seconds.

Emergency Override

The following procedure disarms the system when a programmed re-

mote is not available. Number of presses__________

1. Turn the ignition On.

2. Press the control button on the Control Center the correct

number of times (the default is one press).

3. After a few seconds the siren output ceases and the system

is disarmed.

Note

As a precaution, if programmed for Passive Arming or Auto

re-arming the system should be placed into Valet Mode until

a remote is available .

Trigger Zone Fault Report

When armed by remote command the system runs a status check of

the alarm trigger zones. Faulty zones (usually caused by dome light

delay or open trunk) are bypassed and reported via the control center

LED, while all other trigger zones remain active and are monitored to

protect the vehicle. Should a faulty zone self correct (dome light turns

off) it becomes active and is then monitored normally.

The siren chirps once again a few seconds following the arming chirps as an

audible alert, the control center LED ﬂashes in groups to indicate the zone number.

Alarm Report

If the alarm was triggered while armed, it will be reported when the

alarm is disarmed via siren chirps, parking light and control center

LED ﬂashes. The siren chirps four times (or ﬁve times if NPC On*), the

parking lights ﬂash three times, and the control center LED ﬂashes in

groups to indicate the last two zones that were triggered (see Table of

Zones). The report output will repeat for each disarm operation until

the ignition is turned on.

* See Nuisance Prevention (NPC) for more details.

Table of Zones

Zone # (led flashes) Zone Name

1 Trunk

2 Shock Sensor

3 Door

4 Sensor 2

5 Ignition

6 Hood

Nuisance Prevention (NPC)

NPC monitors all alarm zones and, if any are triggered excessively,

bypasses them until corrected. If a point of entry (trunk, hood, door)

is left open following a forced entry, it is bypassed. It becomes active

again only after being closed.

Bypassed sensors automatically reset after one hour and after the

vehicle is driven. Disarming then re-arming the alarm does not reset

bypassed sensors.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Comentários a estes Manuais

Sem comentários

Ampire 3606V Manual de Instalação Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Ampire 3606V