Ampire 3606V Manual de Instalação descarregar pdf (Página 12)

22 23

Remote and System Operations

Passive Arming*

Park and exit the vehicle, after the doors are closed the Passive arming

countdown begins. The led ﬂashes quickly and upon reaching 20 sec-

onds the siren then chirps once. At 30 seconds the system arms itself.

Anytime before the system arms you can re-enter the vehicle or

open the trunk to load or unload items and, after closing passive arm-

ing resumes.

To stay secure in case of accidental disarming the system, if a

door is not opened within 30 seconds the system re-arms itself and

locks the doors.

Auto Re-arming*

Auto re-arm ensures the vehicle stays protected if it is not entered after

disarming by remote control. After disarming by remote, the alarm

automatically re-arms itself (and locks the doors if programmed on) in

30 seconds. Open any point of entry to stop the re-arm until the next

disarm by remote.

Onetime Bypass*

Turn the ignition On for one to three seconds and then Off. The siren

chirps once to conﬁrm one-time bypass is enabled.

One-time bypass can be used to temporarily bypass the Passive arm-

ing operation for one cycle. It also bypasses the comfort closure and

auxiliary channel outputs if programmed to activate when arming.

After the next disarm all operations return to normal.

* These features must be turned on by an authorized Directed dealer.

Valet Mode

Valet mode can be entered and exited by performing the Remote

Valet command or manually using the vehicle key and the control

button. When entered, the alarm functions are defeated while the

convenience features still operate normally.

Use the following steps to manually enter and exit Valet Mode:

1. Turn the ignition switch On and then Off

2. Immediately press and release the control button once

3. The control center LED turns On when entering and Off when

exiting.

Power Save

To reduce power consumption the control center status LED modiﬁes

its output if the vehicle is parked for an extended period. If Armed the

ﬂashing is reduced after 24 hours. When Valet mode is On the LED

turns off after 1 hour and resets each time the ignition is turned off.

Rapid Resume

If power is ever disconnected by a mechanic or thief, the system will

resume the state it was in at the time of disconnection, when power

is reconnected.

Car Select

Car 2 remote control option must ﬁrst be turned On (See Remote

Control Conﬁguration section to turn on). Press and hold the

AUX

button

for 3 seconds. The LED ﬂashes once or twice to indicate the selected

Car is 1 or 2, release the button for Car Select or continue to hold

for programming.

Release the

AUX

button, then press and release while the LED ﬂash-

es continue to perform Car Select. Once the car is selected a com-

mand can be performed by pressing one of the command buttons.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Comentários a estes Manuais

Sem comentários

Ampire 3606V Manual de Instalação Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Ampire 3606V